WARNING
•
Be sure to read this entire manual thoroughly and you fully understand all the instructions and warning before
attempting to begin your installation.
This product should only be installed by someone who has a basic knowledge of building construction,installation and
fully understands these instructions.
•
•
Make sure that the supporting surface will safely support the combined load of the mount, the display and all
attached hardware and components.
•
This wall bracket will only supporting flat panel displays(LCD,Plasma).The maximum load capacity is 100
pounds.
•
Always have someone assist you to lift and position your equipment.
•
T
•
Screws must be tightly secured,but do not overtighten any screws (especially the four hex bolt screws M8x63.5mm)
or damage can occur and product may fail.
ighten screws and bolts firmly, but do not over tighten. Over tightening can damage the items and greatly reduce
their ability to hold. Please refer to suggested torque values where applicable in these instructions.
Tools Needed for Assembly
Required Tools
Optional Tools
40mm
6mm 10mm
Before you begin, please verify that all components are included and undamaged. If any
parts are missing or damaged, contact Product supplier, Never proceed with missing or
damaged parts!
Lay out all components and make sure you identify that each one has a match in the
diagram. Some of the parts included will not be used during installation. Do not proceed
if you do not understand and identify all of the components.
2 of 8
•
If mounting to a wall of wood stud construction, be sure that mounting bolt are anchored to the center of the studs
，
When installing the TV mount on a concrete wall, the wall must be at least 8"(203mm) thick with a minimum comp-
ressive strength from 2500 to 3000 psi (17.2 to 20.7 MPa),the concrete wall must meet ASTM C39. When installing
the TV mount on a cinder block wall, the cinder blocks must meet ASTM C216 specifications and have a minimum
nominal width of 8”(203mm). Be sure to mount in a solid part of the block, generally 1"(25 mm) minimum from the
side of the block.Do not drill into mortar joints! If plaster/drywall is thicker than 16mm,custom fasteners must be su-
pplied by the installer.
6
Table of Contents
Parts List ........................................................................................................................................................................
........
3
Assembly Outline
. .
.. ..................
. .
.. ..............................
...............................................................................
4
Install to Solid Concrete or Cinder Block
................
................
........................................................................................
Install to Single Wood Stud Wall ....................................................................................................................................
5
7
Installation of the screen .................................................................................................................................................
8
Product dimensions ........................................................................................................................................................