Insert spacer
bolts B and A into
the holes in the
upper cover
where you just
removed the
screws.
» Note:
The
bolts are
labeled. Make
sure you use
the correct
bolt.
Snap the paper
guide into place.
Remove the two
screws in the
lower cover.
Insert the two
spacer bolts (C)
into the lower
cover holes
where you just
removed the
screws.
» Note:
The
bolts are
labeled. Make
sure you use
the correct
bolt.
Use a small flat-
bladed
screwdriver to
pop out the two
small panels from
the bottom cover.
Use the two
captive screws to
install the stopper
guide where the
square panels
were located.
Use the four
captive screws
on the joining
frame to attach
the joining frame
to the spacer
bolts.
!
Roll the two units
together.
Lift the LCOS a
little to make sure
that the connect-
ing pin on the
stopper guide is
aligned with the
stopper hole on
the LCOS, and
then push the
LCOS against
the printer.
Plug the interface
cable from the
LCOS into the
connector on the
back of the
printer near the
bottom.
Plug one end of
the power cable
into the LCOS
and the other end
of the cable into a
grounded outlet.
»
Note: Refer to chapter 6, “Hardware Options,” in the Options manual (on the 4060 Document CD-ROM) for instructions on using the 3000-sheet LCOS.
3
'#,%
'#*%
!
4
#%
5
'#-%
6
! '
9
10
"
. "+
11
- "
"
'
'
Note:
The two metal pins on the back of the LCOS are
connected to the corresponding holes in the joining
.
frame, and the printer latch is engaged.
1
/ +'
!')
/ +
-
QMS is a registered trademark of QMS, Inc.
Copyright
©
1999 by QMS, Inc. All Rights Reserved.
