QMS 2425, Справочник

Страница: 117 / 244

'XSOH[LQJ
3ULQWHU&RQILJXUDWLRQ
(QJLQH
Through the Administration/Engine menu you can set print engine-
related parameters.
$GMXVWLQJWKH,PDJH$OLJQPHQW
This option allows you to adjust the horizontal and vertical placement
of printed images.
To check image alignment, print a standard status page (Print Status
key). When the printer is placing images properly, the alignment angle
bar in the lower-left corner of the status page is 0.5"/12.7 mm from
the left and bottom edges of the page. If the angle bar is off, use the
Administration/Engine/Image Alignment option to align the image hor-
izontally and vertically in pixel increments (1/300” or 0.08 mm).
» Note: Engine constraints may limit the accuracy of pixel alignment.
+RUL]RQWDO2IIVHW
9HUWLFDO2IIVHW
Menu Administration/Engine/Image Alignment/Horiz Offset
Choices
000-300 (0.00"/0 mm-1.00”/25.4 mm)
Default 100 (0.33"/.84 mm)
Notes
Values above 100 move the image to the right.
Values below 100 move the image to the left.
Menu
Administration/Engine/Image Alignment/Vertical Offset
Choices 000-300 (0.00"-1.00”)
Default
100 (0.33"/.84 mm)
Notes Values above 100 move the image down.
Values below 100 move the image up.