Pub #9000145 Revised: 02/2018
For more information visit us at qmotionshades.com or call 877.849.6070
© 2018 QMotion. QMotion is a trademark. All rights reserved.
8. Terminate wires at Power Distribution Box in pairs. Place screw driver
into dark square slot above the terminal you want wire to go into. Pry
upward and the terminal jaws should spring open. Then slide stripped
wire into bottom cavity but not insulation portion. Release the prying
pressure on the screw driver. Terminal should bite down on the wire.
Apply a light tug to test your terminal connection.
9. Connect the Power Cord to the Wall Outlet. The shades are now
waiting to learn a remote.
10. Please see Qadvanced Roller Shade Gen. 3 Programming
Instructions for pairing the remote and learning shade limits.
Motorized Roller Shades
QLVS-433, QMLV-433FM
LOW VOLTAGE SHADE
CAN RSS-Gen/CNR-Gen.
FCC Regulatory Statements:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions.
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this device not expressly approved by QMotion Advanced Shading Systems could void the user’s authority to
operate the equipment.
Industry Canada Regulatory Statements:
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada
This Class B digital apparatus meets all requirements of the Canadian Intereference Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Reglement Canadien sur le matériel bouilleur.
Do not operate at temperatures below 32° F or above 130° F. End user must ensure that shade being used is fire resistant. Keep transmitter away
from children. Periodically examine assembly and brackets for signs of wear and discontinue use if repair is necessary. The controller and transmitter
assemblies contain no serviceable parts.
Ton de Zeeuw
Contact for QMotion
Raritan Europe B.V.
Jan van Galenstraat 59
3115 JG Schiedam
The Netherlands
Tel: +31.(0)10.2844040 • Fax: +31.(0)10.2844049
VAT: NL803738614B01 / KvK-CoC: 24256806 / EORI: NL803738614
Wire Length (ft.)
for 24VDC
Minimum Wire Gauge
1500-3000
12
1200-1500
14
700-1200
16
500-700
18
0-500
20
