LOW VOLTAGE ROLLER SHADE
DISTRIBUTION BOX
INSTALLATION INSTRUCTIONS
IMPORTANT
Read and understand all instructions before installing.
This document assumes that you have already installed roller
shade brackets.
We do not recommend installing the shade’s wired end in the
locking bracket. Read and understand all instructions before
installing. Always wear personal protection equipment including
safety glasses and gloves. Use a ladder per its manufacturer’s
instructions. Work safely!
Tools Required
• Measuring Tape
• Wire Strippers
• Ladder
• 1/8” Flat Head Screwdriver
Materials Required
• Wire (See table on next page)
Recommended Items
• Wire Management Clips
PARTS LIST
Part
Quantity
Power Supply
1
Power Cord
1
Power Distribution Box
1
Male Quick Connector
1 (per shade)
Female Quick Connector 1 (per shade)
Power Supply
Power Cord
Quick Connectors
Power
Distribution
Box
INSTALLATION
1. Lay out the Power Supply, Power Distribution Box,
the shade(s), and any wiring/cordage. Ensure that
cords and wires are of sufficient length and that Power
Supply and Power Distribution Box are located away
from water and flammable materials.
2. Connect the Power Cord to the Power Supply
IMPORTANT:
Do not
connect the Power Cord to the
wall outlet at this time!
3. Connect the Power Supply to the Power Distribution
Box.
4. Place the shade in the brackets and route the shade’s
wires in such a way that they are hidden from view, but
still accessible. Use wire clips as needed for routing.
5. Route power wires from Power Distribution box to
shade.
6. Strip jacket 1/4 inch. Use 1/8 inch flathead screwdriver
to install Quick Connector on wires. Polarity does not
matter.
7. Terminate Quick Connector to shade’s connector.
Around Back
Through Keyhole
