QMAXZ Lighting QS Series, Руководство пользователя

Страница: 26 / 36

QS series manual v3.09 QMAXZ © 2009 - 25 -
8.3 Gobo positions
Gobo positions Wheel 1(rotating):
Position 1 = QGG1
Position 2 = QGG2
Position 3 = QGG3
Position 4 = QGG4
Position 5 = QGG5
Position 6 = QGG6
Position 7 = Open
Gobo positions Wheel 2(fixed):
Position 1 = QGM1
Position 2 = QGM2
Position 3 = QGM3
Position 4 = QGM4
Position 5 = QGM5
Position 6 = QGM6
Position 7 = QGM7
Position 8 = QGM8
Position 9 = Open
8.4 Gobo replacement
The fixture head has a top and bottom cover, to determine witch cover is the top or bottom turn the
fixture head horizontally with the lamp housing back plate towards you, the text on the back plate
should be in normal readable position.
Replacing fixed / metal gobo
1. Disconnect the fixture from mains power and let it to cool down completely.
2. Turn the fixture head horizontally with the bottom cover on top, and lock the head with the tilt
lock.
3. Remove the bottom cover of the fixture using a Philips head screwdriver to loosen the 4
screws, the screws are locked for falling out so the can not be taken out completely, lift the
cover and loosen the safety cable on the back side.
4. Remove the white glue with a sharp small knife carefully, the glue is attached in the factory as
an extra precaution to prevent the gobo of coming out, under normal conditions the glue is not
necessary but QMAXZ advises to put glue on when the gobo is replaced.
5. Lift the gobo a little bit from the wheel and pull it towards you to take it out.
6. Put in a new gobo by sliding it in the pocket on the wheel, and secure it with a drop of glue.
7. Attach the safety cable of the cover again, and put the cover back on, tighten the 4 screws.