Qlogic QConvergeConsole CLI 2400 Series, Руководство пользователя

Страница: 110 / 366

6–iSCSI Noninteractive Commands
-bootcodemode (Set BIOS/UEFI [or FCode] Mode)
6-4 SN0054667-00 C
The
-bootcode
command updates the boot code image, which should be done
when QLogic releases a new boot code with bug fixes or enhancements. At the
prompt, type the name of the file containing the boot code image to upload to the
adapter.
To update the boot code image, issue the
-bootcode
command as follows:
-bootcode <hba_port_inst> < Bootcode Code Image File Name >
-bootcodemode
(Set BIOS/UEFI [or FCode] Mode)
To set the boot code mode for QLA4050, QLA4050C, QLE4060C, QLE4062, and
QMC4052 adapters, issue the
-bootcodemode
command as follows:
-bootcodemode <hba_port_inst> <1>|<2>|<3>
Where:
If adapter DHCP is enabled (see “-ipdhcp (Configure IP Settings)” on page 6-13 ),
modes 1–3 are allowed. If adapter DHCP is not enabled, boot code DHCP is not
allowed. This mode is not supported for QLA4010 adapters. This mode is not
active for the PPC.
For IBM cards, the following modes are available:
-c
(Display Configured Port Settings)
To view the configured settings for the port, issue the
-c
command as follows:
-c [ hba_port_inst ]
When you specify a port instance, information for only that adapter is shown.
When you do not specify a port instance, information for all adapter ports in the
system is shown.
1 = Disabled
2 = Manual mode
3 = DHCP–Root path
4 = DHCP vendor ID
5 = DHCP-auto
6 = Auto
7 = System mode
NOTE:
Boot code DHCP is not allowed for QLA4010 adapters.