4
57
Max. 7 meters
Insulating strip
Remove
SETTING THE TIMER
This timer can be used to delay the appliance startup or shutdown, this avoids wasting
electricity by optimising operating periods.
Programming start up
• Turn on the appliance, choose the mode you want, for example cool, 24°C, high
fan speed.
Turn off the appliance.
• Press the
button, the screen will display 1-24 hours, and the symbol and
symbol and symbol are flash together.(fig 3)
• Press several times until the corresponding time is displayed.Wait about 5
seconds, the timer will be active, then only the symbol is displayed on screen.
(fig 4)
• Press again the button or the button, the timer will be canceled, and the
symbol will disappear from screen.
Programming shut down
• When the appliance is running, press the button, the screen will display hours,
and several symbols are flash together. (fig 5)
• Press several times until the corresponding time is displayed. Wait about 5
seconds, the timer will be active. then only the symbol is displayed on screen.
(fig 6)
• Press again the button or the button, the timer will be canceled, and the
symbol will disappear from screen.
Fig. 5
Fig. 6
Fig. 7
Replacing the Battery
To replace the battery, follow the steps below:
1 Use a screwdriver to remove the screw that secures the battery cover;
2 Push the latch to the right side and pull the battery cover out;
3 Replace the battery and slide the battery cover back into the remote;
4 Replace the screw that secures the battery Cover.
Fig. 3
Fig. 4
Fig. 1
Fig. 2
SELF-DIAGNOSIS
The appliance has a self diagnosis system to identify a number of malfunctions.
Error messages are displayed on the appliance display.
IF IS DISPLAYED
WHAT SHOULD I DO?
LOW TEMPERATURE
(frost prevention)
The appliance is fitted with a frost protection device
to avoid excessive formation of ice.
The appliance starts up again automatically when
the defrosting process is completed.
PROBE FAILURE
(sensor damaged)
If this is displayed, contact your local authorised
service centre.
FULL TANK
(safety tank full)
Empty the internal safety tank, following the
instructions in the “End of season operations”
paragraph.
E
MANUAL OF REMOTE CONTROL
4.7
Fan button
Swing button
Sleep button
Increase button
Decrease button
On/Off button
Mode button
Timer button
Unit Switch button
Point the remote control at the receiver on the appliance.
The remote control must be no more than 7 meters away from the
appliance (without obstacles between the remote control and the receiver).
The remote control must be handled with extreme care. Do not drop it or
expose it to direct sunlight or sources of heat. If the remote control do not
work, please try to take out the battery, and put it back.
4
56
