This product has a volume(1) for controlling revolving speed and
voltage selection switch(2) on assembling board. Refer to above
structure drawing together with below drawing and explanation for
right operating.
1) Lens(Protection Cage) Removal
Remove Protection Cage② and Lens③ from the product by
loosening bolt(M4-4EA)① and make sure assembling board④.
2) Revolving Speed Control
▪ The volume(1) for revolving speed control is built-in this
product. Turn it closckwise for increasing revolving speed and
turn it counterclockwise for decreasing revolving speed.
▪ If give excess power to the volume, it can be broken.
Be careful !
3) Bulb Change
※ Warning ! ! Turn off Power
Must turn off power supply and change the bulb after at least
1 minute.
▪ Make sure the rated voltage and wattage of new bulb. If the
voltage of new bulb is higher than that of original bulb, the
self-life of product can be reduced and can cause damage on
lens and reflector. Therefore, please use same bulb as original
one which has same rated voltage and wattage or lower one.
▪ Bulb Removal : Press slightly the bulb downward and turn it
counterclockwise for removing.
▪ Bulb Fitting : Fit new bulb into the socket by pressing it
clockwise.
Bulb Removing Bulb Fitting
4) Lens(Protection Cage) Assembling
Assemble the lens(or Lens and Protection Cage) in reverse order
of separating.
Refer to structure drawing together with below drawing and
explanation for right operating.
1) Body Cover Removal
▪ Remove body cover⑥ by loosening body cover bolt(M5 4EA)⑤
and make sure related parts on phone control board.
2) Sound Tone Selection
▪ 5 Warning sound tones are built-in this product. In case of
standard product, select preferable sound tone by using internal
sound tone selection switch(S1).
▪ In case of LC Type(Custom-Made) product,refer to below
explanation and drawing.
3) Volume(dB) Control
▪
Volume controller(S2) is built-in this product. Turn it clockwise
for increasing volume or turn it counterclockwise for decreasing
volume
4) Wiring Power Line
▪ Make sure terminal plate⑦ inside the body of the product.
▪ Treat the end of power cable by using “O” or “U” type terminal
for safe wiring.
▪ Connect power cable to terminal plate.
▪ In case of product using AC voltage, connect the line without
polarity(wire color).
▪ In case of product using DC voltage, black line is negative(-).
ООО “РусАвтоматизация”
454010
Челябинск, Гагарина 5,
русавтоматизация.рф
Россия,
тел. 8 800 775 09 57
, +7(351)799 54 26,
тел./факс +7(351)211 64 57
(звонок бесплатный)
,
[email protected], www.rusautomation.ru,
