Rev.1.1
3
2016.06.14
•Earth by using M4 spring washer head screw(STS type)
•In case of earth wiring, use 0 type terminal (internal diameter
∅
4.2) on the body.
•O type terminal shall be made of C5212 or same level of
conductor.
•Diameter of the earth wire shall be 4 mm or higher.
•Common line (-)must be grounded.
9. How to wiring
Both power line and signal line come out. Power & sound
line shall be interconnected. Refer to wiring diagram as below.
■DC Steady type
▪
Specification : UL1007-NO.22(0.3sq) 400mm
▪
Connect black line and negative(-) line each other
10. How to install
▪
This product is intended for indoor use only. Do not use for
outdoor use.
▪
Install vertically as much as possible. Avoid vibration and
impact.
▪
Pierce appropriate holes on the place to be installing the
product in advance by referring below hole size.
▪
Direct Mounting type shall be fixed by using the nuts(M4-3EA)
bottom of the product.
ST45ML-Ex
Series
PCD 30, Ø5x3
11. Trouble Shooting
Symptom
Reason
Solution
No light
Wiring error
Check wiring
Dim light
Supply lower voltage
than
standard
requirement
Check voltage
LED signal lights cannot
be divergence partially
Supply higher voltage
than
standard
requirement
-
LED
damage
Check voltage
- Customer Service -
www.microlectra.nl [email protected]
Microlectra bv.
Augustapolder 12. 2992 SR Barendrecht. The Netherlands.
www.microlectra.nl [email protected]
