3
•
First, machine holes on the mounting surface
•
The mounting hole of this product is 9mm in diameter.
• If the tap is machined, fasten the bolt through the
mounting hole of the product.
• When machining holes, insert the bolt through the hole of the
product, and tighten the nut from the opposite side of the
mounting surface.
• When adjusting the phase and lower angle of the mixed housing
after product cancellation Loosen the bracket fixing bolts(
①
)
on the side of the product slightly to adjust the desired angle.
■
Installation
■ Adjusting the Angle of the Horn Housing
Housing
(ABS)
Bolt
①
■ Sound Type by Group
Category
Sound
pattern
Channel
Sound tone
Volume (Max.)
SRN,
SEN15 SEN25
WS
5 Warning
sounds
Ch1
Fire.A-ANG
108dB
115dB
Ch2
Emergency WA-U
Ch3
Ambulance PI-PO
Ch4
Machinery Fault
Ch5
High Expansion
WM
5 Melo-
dies
Ch1
Sweet Home
108dB
115dB
Ch2
For Elise
Ch3
Cuckoo's Waltz
Ch4
Piano Sonata
Ch5
Turkish March
WA
5 Alarms
Ch1
Beep Intermittent
105dB
113dB
Ch2
Door Chime
Ch3
Phone Ring
Ch4
PI.PI.PI Short
Ch5
Tripping Beat
WV
5 Cus-
tomizable
sounds
Ch1-
Ch5
Available upon
request
(customized voice
type)
98dB
108dB
• The volume output of this product
is adjustable.
• Turn the volume dial clockwise to
increase the volume, and turn
counter clockwise to decrease the
volume.
• There will be no sound when the
dial is put at MIN.
Volume Dial
VOL.
MAX.
MIN.
• Standard unit has 5 built-in sound tones.
Select different built-in sounds using the sound setting switch(
①
).
ON
1 2 3 4 5
ON
DP
1 2 3
Sound Setting Switch(
①
)
Volume Dial
Parts Definition/ Installation
■
Parts Definition
Sound Selection
Mounting Hole Specifications
Installation Environment and Protection Rating
• This product is designed for use with protection rating of IP55.
• If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating indicated(IP55),
it may cause malfunction or damage to the product.
• In case of outdoor applications, install the product in the upright position. Do not install the product horizontal or upsidedown positions where
water can potentially penetrate into the product and impact it’s operation.
• For further information, please visit our website (www.qlight.com).
3-Ø9 HOLES
3-Ø9 HOLES
50
82
• Machine holes on the mounting surface referring to the diagram below.
SEN15/ SEN25
SRN
Volume Adjustment
■ Adjusting the Angle of the Horn housing
