3
Min. Ø5 CABLE ENTRY
3-
Ø
6 HOLES
3-Ø
9 HOLES
Min. Ø5 CABLE ENTRY
PCD 155
PCD 96
S150R/ S150U
S150R-FT/ S150U-FT
Parts Definition/ Installation
Mounting Hole Specifications
• Machine holes on the mounting surface referring to the diagram below.
Lens(PC)
Mounting bracket(STS)
Reflector
(Heat resistant ABS)
Light bulb
■ Parts Definition
•
First, remove the flange nuts from bolts and place
the product through the mounting surface holes.
•
Fasten the flange nuts on the opposite side of the
mounting surface until the product is tightened securely.
■ Installation
S150R/ S150U
S150R-FT/ S150U-FT
Housing(STS) S150R(FT)
Housing(ABS) S150U(FT)
Flange nut
Flat washer
Rubber spacer
Installation Environment and Protection Rating
• This product is designed for use with protection rating of IP44.
• If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating
indicated(IP44), it may cause malfunction or damage to the product.
• In case of outdoor applications, install the product in the upright position. Do not install the product horizontal or upside-
down positions where water can potentially penetrate into the product and impact it’s operation.
• For further information, please visit our website (www.qlight.com).