2. Knob will lock into one of four detents in side of machine.
OPERATION
Starting Qleeno
1. Qleeno requires the use of an extension cord. Handle should be upright and locked.
2. Mount brush or pad holder with scouring pad according to the instructions on previous page.
3. Connect to common household current (110V) electrical outlet via extension cord.
4. Tilt Qleeno backwards slighlty before starting to avoid damaging the scrubber. Start Qleeno by pressing Start/
Stop Scrubber button on control pattern. The machine will perform a brief function test, after which the scrub
-
ber, water flow and suction will all commence.
5. Regulate water flow with Decrease Water Flow or Increase Water Flow buttons on control panel. Adjust water
suction with button shown below.
1. Start/Stop Scrubber
3. Decrease Water Flow
6. Start/Stop Suction
2. Scrubber Indicator Light
4. Water Flow Indicator Lights
7. Suction Indicator Light
5. Increase Water Flow
8. Warning Light (red)
Normal Operation
Best results can be obtained by always using a full tank of clean water and chemical (if required). Move Qleeno
in slow, overlapping lines over one portion of the surface at a time.
NOTICE:
Change direction slowly - do not move Qleeno in sudden or jerking motions.
Judicious monitoring of water flow should provide the user with approximately 10 - 25 minutes of working time
(low water flow setting - .03 gal/min; med water flow setting - .05 gal/min; high water flow setting - .10 gal/min).
Turning off Qleeno
1. Turn off water flow by pressing Decrease Water Flow button on control panel until all indicator lights go out.
Continue cleaning for ten seconds to collect any excess water.
2. Turn Qleeno off by pressing Start/Stop Suction button on control panel. Suction will continue for an additional
two seconds.
3. Disconnect power cord from power source.
4. Empty dirty water tank.
7
1
2
3
4
5
6
7
8
