Qindao Hichanse Group ALZ513, Руководство по сборке

Страница: 7 / 16

●
If the appliance is not in use,the gas must be turn off at the supply cylinder.
TIPS:
Before Beginning
●
Read the instructions thoroughly.
●
Check and make sure that all parts are present.
Before each use, inspect all hose. Replace hose if there are any signs of cutting, wear or abrasion.
(1) Turn the T-handle on the gas tank counter-clockwise to open the gas supply.
(2) Close the storing door on the firepit for the gas tank.
(3) Light the firepit as below steps:
A. Push and turn the Control Knob counter-clockwise to the "LOW" position. Keep pushing the Control Knob. Meanwhile press and hold
the Electric Ignitor to light the burner .
B. After ignition, release the Electric Ignitor. Continue to push and hold the Control Knob for 15 seconds.
C. If ignition does NOT immediately take place in seconds, push and turn the Control Knob clockwise to "OFF". Wait 5 minutes, then
repeat the lighting procedure as above.
TO LIGHT
WARNING
●
Do not use an open flame to check for leaks.
4. If something is leaking, you will see bubbles form. In case of leaks, turn off the gas supply, undo the leaking connection, re-connect
and try again. If the leak persists, consult Sunjoy Industries Customer Service Center for assistance.
●
For future reference, save this instruction sheet.
1. Make sure the control knob is on the “OFF” position.
●
Do not smoke during testing.
●
Do not test indoors.
●
A leak check must be performed whenever the gas cylinder is replaced.
2. Make sure the gas cylinder is correctly and securely connected to the pressure regulator, without over tightening it.
3. Turn on the gas cylinder valve. Apply 50% soap and 50% water solution to the gas hose and connections between the control knob
and gas cylinder.
This screen must be clear and free of
obstructions at all times to insure proper
operation.
WARNING
DO NOT PUT FAKE WOOD
ON THE SCREEN.KEEP
SCREEN.CLEAR.
7