QIMMIQ SPLASH DRONE 3, Руководство по эксплуатации Manualline

Страница: 14 / 28

14
- The drone has been subjected to unstable GPS signal/s or spurious interference/effects on the
Compass module during flight.
- The calibration of the drone (compass and/accelerometer) was incorrectly carried out.
- The battery cable was not correctly positioned, behind the battery and as far as possible from
the compass module.
Steps that can be taken to resolve the issues:
- Re-calibrate both the compass and accelerometer on the Qimmiq Splash Drone 3.
- After completing the calibration, arm the drone motors to fly, whilst in GPS mode, to verify
whether this phenomenon has been eliminated.
- If the abnormality remains the same, please re-locate to another place at least 5KM away and
re-calibrate the drone. Following the re-calibration, please test the drone again.
- If the problem persists, please contact Qimmiq or your local dealer for further trouble-shooting
and solutions.
4. Maintenance
- Please make sure to double check the propellers after flight, distorted/damaged props should
be replaced immediately.
- After flying over the sea or other corrosive waters, please wash the outer modules of the drone
with fresh water within 2 hours, especially the motors, the gimbal structure, and mounting
brackets of the landing gear.
- It's strongly advised to rinse the drone before the salt crystalizes. A mild solvent can be used to
clean off the crystalized salt completely, please contact your local dealer, or Qimmiq for detailed
guidelines.