Deprogramming all user cards:
- To deprogram all user cards, hold the Admin card that was used to program the user cards in front of the lock
for about 5 seconds until it flashes red one time, remove the card; Then hold the Admin card again about 5
seconds until it flashes red twice, remove the card.
- All user cards that were programmed with this Admin card will be deprogrammed at the same time. If several
Admin cards are used, this procedure will have to be carried out separately for each Admin card.
- The Admin card remains valid.
III. Additional instructions
Timeout:
-
The programming or deprogramming mode is terminated when no action is carried out (i.e. the card is
neither introduced nor removed) for approximately 10 seconds.
-
The programming or deprogramming mode will be stop when the action is incorrect (flashes red)
-
When the RFID lock is unlocked with a user card, the door has to be opened within 5 seconds. otherwise,
the RFID lock will relock automatically.
Visual Indications
-
Green light flashing (3 times) for the below cases:
-
1) The RFID card was recognised, i.e. this card has already been programmed with this particular LOCK.
-
2) Confirmation that the action (programming or deprogramming) was successfully completed.
-
Red light blinking for the below cases:
-
1) The RFID card was not recognised, i.e. this card has not yet been programmed with this particular LOCK.
2) Presented the wrong card when programming or deprogramming
Public / Private Mode
When the lock is in private mode there are no visual indications
When the lock is in public mode locks that are in use will flash red every 5 seconds to show that they are in use
Emergency Opening
- Unlock by Admin key if losing the user card or by the mechanical master key. The master key can be used to
open the lock at any time. This does not affect the lock programming in any way.
Low battery alarm
-The alarm will sound if the battery is low and the LED will flash red 5 times warning users to replace the battery
soon.
Changing the Battery
1.
Remove fixing screw
2.
Rotate the lock down over the edge of door
3.
Take out the batteries
4.
Put in the new batteries and screw lock back into place
www.qilocks.com [email protected] +44 (0)20 8906 6881
