-
5 -
SA
W OPERATION
•
TAKE OUT THE ELECTRICAL CORD
to connect to the power sour
ce. The
electrical cord is stored underneath the cutter. (See Diagram 3)
•
RAISE THE BLADE GUARD
up to the highest position, then open the left
cutting table to fill the reservoir with water to the recommended level.
Attention! Keep water level with lines. (See Diagram 4)
•
LOWER THE BLADE GUARD
above the blade.
•
FOR STRAIGHT CUTTING,
after the tile guide is positioned for the desir
ed cut,
place the material flush against the tile guide then push the material forward of
the blade. (See Diagram 5)
•
FOR MITER CUTTING, raise the right cutting table to the desir
ed angle and
select either 15°, 30°, 45° or 60°. Put the two stands into the grooves to hold
the cutting table in place. Place the material face down onto the right cutting
table and you are ready to cut. (See Diagram 6)
•
FOR ANGLE CUTTING, choose the degr
ee you want and tighten the handle.
Then, push the miter guide and material together forward of the blade to cut
the material. (See Diagram 7)
DIAGRAM 3
DIAGRAM 5
DIAGRAM 4
DIAGRAM 6
DIAGRAM 7
SA
W MAINTENANCE
WARNING: DO NOT SERVICE, CLEAN OR MAINTAIN THE SAW WITHOUT FIRST TURNING OFF THE MOTOR AND
UNPLUGGING THE SAW FROM ITS POWER SOURCE. FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY TO THE
OPERATOR.
For the longest life and best per
formance:
•
Always clean the tile cutter after each use.
•
Wipe off all exterior surfaces and keep the cutting table clean and free of tile chips and debris.
•
Always let the blade cut at its own speed. Do not force the material being cut.
•
Always check the blade for cracks or signs of fatigue.
•
Always clean the reservoir thoroughly after use.
•
Always store the electrical cord underneath the cutter after use.
•
Always keep water level at the recommended level. Do not overfill or allow the cutter to run dry.
•
Always store in a dry environment.
•
Never attempt to service the internal parts of the motor by yourself as this will void your guarantee.
