QEP 22400Q, Руководство пользователя

Страница: 9 / 36

– 7 –
figure 5
2 . Create “drip loop” in the cord (see FIGURE 5) .
USinG tHe extenSiOn taBLe
1 . The extension table can be used to support
large format tile .
2 . Simply slide it out for the best support for the
size of the tile your are cutting .
maKinG CUtS
The edge of the cutting table has easy-to-see
dimensions (in both inches and centimeters) for
cutting accuracy .
IMPORTANT: ALWAYS LET THE BLADE CUT AT
ITS OWN SPEED. DO NOT FORCE THE MATERIAL
BEING CUT. ALWAYS CHECk THE BLADE FOR
CRACkS OR DAMAGE BEFORE EACH USE.
maKinG 90° riP CUtS
1 . Install the rip guide by placing it at the desired
position according to the width of the cut you are
making .
2 . Place the material to be cut against the
rip guide .
3 . Carefully and slowly feed the material into the
blade (see FIGURE 6) .
4 . If necessary, the rip guide can be removed
when cutting large format tile .
maKinG anGLe CUtS
1 . Install the angle guide on the top of the
rip guide .
2 . Carefully push the angle guide and material
towards the blade (see FIGURE 7) .
figure 7
maKinG 22.5 ° - 45° miter CUtS
(see FIGURE 8)
1 . The right cutting table can be angled at 22 .5°
or 45° .
2 . Two braces under the table unfold to support
the table at the desired angle .
3 . Place the material to be cut onto the right
cutting table .
4 . Carefully and slowly feed material into the
blade .
figure 8
MAINTENANCE
TO AVOID ACCIDENTS,
ALWAYS DISCONNECT THE TOOL FROM
THE POWER SOURCE BEFORE CLEANING OR
PERFORMING ANY MAINTENANCE
Drip loop
Power supply cord
Tile cutter
Supporting
surface
figure 6