Manual for ZillioX 9
ATX Power Supply Connector & Power Switch (POWER)
Be sure to connect the power supply plug to this connector in its proper orientation. The
power switch (POW ER) should be connected to a momentary switch (power button).
When powering up your system, first turn on the mechanical switch of the power supply (if
one is provided), then push once the power button. When powering off the system, you
needn’ t turn off the mechanical switch, just Push once
*
the power button.
Note: * If you change “soft-off by PWR-BTTN” from default “Instant-off” to “Delay
4 Secs” in the “POWER MANAGEMENT SETUP” section of the BIOS, the power
button should be pressed for more than 4 seconds before the system powers
dow n.
Hard Disk LED Connector (HD LED)
The connector connects to the case’ s IDE indicator LED indicating the activity status of
IDE hard disk. The connector has an orientation. If one way doesn’ t work, try the other
way.
Reset Switch (RESET)
The connector connects to the case’ s reset switch. Press the switch once, the system
resets.
Speaker Connector (SPEAKER)
The connector can be connected to the speaker on the case.
Power LED Connector (PWRLED)
The power LED has two status. When the system is in power-off status, the LED is off.
When the system is powered up, the LED is on. The connector has an orientation.
Key-Lock Connector (KEY_L)
The connector can be connected to the keyboard lock switch on the case for locking the
keyboard.
Installation Instruction
10
POW ER
ATX Power Supply Connector
1
20
3.3V -12V GND PSON GND GND GND -5V 5V 5V
3.3V 3.3V GND 5V GND 5V GND PS-OK 5VSB 12V
