QDI BrillianX 1S/2000, Руководство пользователя

Страница: 47 / 63

Manual BrillianX 1S/2000
Note: 1. If this option(Password) is chosen,
the jumper JP2 must be set as PIN1&PIN 2
closed, or this will prevent you from power-
ing up your system.
2. The keyboard password must be set no
more than 6 characters and can only use the
numbers and alphabetic letters. The pass-
word will always remain unless you clear
CMOS or reset it .
l KBC input clock 6MHz, 8MHz PS/2 keyboard input clock.
12MHz,16MHz
l Onboard FDC Enabled Onboard floppy disk controller is enabled.
Controller Disabled Onboard floppy disk controller is disabled.
l Onboard Serial 3F8/IRQ4, Defines the onboard serial port address and required
1/2 2F8/IRQ3, interrupt number.
3E8/IRQ4,
2E8/IRQ3,
Auto Onboard serial port address and IRQ are
automatically assigned.
Disabled Onboard serial port is disabled.
l Uart 2 Normal Defines Serial Port 2 as standard serial port.
Mode ASKIR Supports SHARP ASK-IR protocol with maximum
baud rate up to 57600bps.
IrDA Supports IrDA version1.0 SIR protocol with
maxiumum baud rate up to 115.2Kbps.
l Onboard Parallel 378/IRQ7, Defines onboard parallel port address and IRQ
Port 278/IRQ5, channel.
3BC/IRQ7
Disabled Onboard parallel port is disabled.
l Parallel Port Mode SPP Defines the parallel port mode as
EPP Standard Parallel Port (SPP), Enhanced
ECP, Parallel Port (EPP), or Extended
ECP+EPP Capabilities Port (ECP).
l PWRON After Off The system resumes OFF when the AC power
PWR-Fail supply powers on.
O n The system will be powered up when the AC
power supply powers on.
Former-Sts W hatever the system status is, before the AC
power supply powers down, the system resumes
in the previous status (ON/OFF) when the AC
power supply powers on.
44
Award BIOS Description