QDI ADVANCE 10B, Руководство пользователя

Страница: 20 / 61

Manual for Advance 10B/Advance 10F
Parallel Port Connector and Serial Port Connector (UART1, UART2)
The parallel port connector can be connected to a parallel device such as a printer, while
the serial port connector can be connected to a serial port device such as a serial port
mouse. You can enable/disable them and choose the IRQ or I/O address in “Integrated
Peripherals” from AWARD BIOS SETUP.
Line-in jack, Microphone-in jack, Speaker-out jack and
MIDI/Joystick connector (option)
The Line-in jack can be connected to devices such as a cassette or minidisc player for
playback or recording. The Microphone-in jack can be connected to a microphone for voice
input. The Speaker-out jack allows you to connect speakers or headphones for audio
output from the internal amplifier.
The MIDI/Joystick connector allows you to connect a game joystick or a MIDI device.
Note: The jacks and the MIDI/Joystick connector shown above are available for
Advance 10B mainboard with AC’97 codec only.
ATX Power Supply Connector & Power Switch (POWER)
Be sure to connect the power supply plug to this connector in its proper orientation. The
power switch (POWER) should be connected to a momentary switch (power button).
When powering up your system, first turn on the mechanical switch of the power supply (if
one is provided), then push once the power button. When powering off the system, you
needn’t turn off the mechanical switch, just Push once
* the power button.
Note: * If you change “soft-off by PWR-BTTN” from default “Instant-off” to “Delay
4 Secs” in the “POWER MANAGEMENT SETUP” section of the BIOS, the power
button should be pressed for more than 4 seconds before the system powers
down.
Installation Instruction
16
POWER
ATX Power Supply Connector
20
MIDI/Joystick
Speaker out
Line in
Microphone in
Parallel Port
UART1
UART2
1
For Advance 10B
mainboard only