Qcom Q802XKG, Руководство пользователя

Страница: 16 / 17

16
This device is intended only for OEM integrators under the following conditions:
1.
The antenna must be installed such that 20 cm is maintained between the antenna
and users, and
2.
The transmitter module may not be co-located with any other transmitter or antenna.
3.
For all products market in US, OEM has to limit the operation channels in CH1 to
CH11 for 2.4G band by supplied firmware programming tool. OEM shall not
supply any tool or info to the end-user regarding to Regulatory Domain change.
As long as 2 conditions above are met, further transmitter test will not be required. However,
the OEM integrator is still responsible for testing their end-product for any additional
compliance requirements required with this module installed (for example:
Notebook,
Wireless Router…etc.
).
IMPORTANT NOTE:
In the event that these conditions can not be met (for example certain
laptop configurations or co-location with another transmitter), then the FCC authorization is no
longer considered valid and the FCC ID can not be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be
installed such that 20 cm may be maintained between the antenna and users (for example:
Notebook, Wireless Router…etc.)
The final end product must be labeled in a visible area
with the following: “Contains TX FCC ID: RUJ-Q802XKG”.
Manual Information That Must be Included
The OEM integrator has to be aware not to provide information to the end user regarding how
to install or remove this RF module in the user’s manual of the end products, which integrate
this module.
The user’s manual for OEM integrators must include the following information in a prominent
location “
IMPORTANT NOTE
: To comply with FCC RF exposure compliance requirements, the
antenna used for this transmitter must be installed to provide a separation distance of at least
20 cm from all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter.
3