9
Then in the Qcam QSD-722 widget go to the "Option" page. On the option page change the settings mode to
"Custom Mode" and Save.
To configure the custom recording settings please select the settings tab. Remember to sync the settings once
you have selected the options you prefer.
The default mode settings are as follows
Continuous
Triggering
Custom (default)
Video Quality*
High
High
(High) / Medium/ Low
Resolution*
1280x720
1280x720
(1280x720) / 640x360
Frame Rate*(1)
High
High
(High) / Low
Indoor Lighting Condition(2) 50Hz
50Hz
(50Hz) / 60Hz
Day/Night Mode(3)
Day Mode
Day Mode
(Day Mode) / Night Mode / Auto Switching
Orientation
Normal
Normal
(Normal) / Upside Down
Time Stamp
Enable
Enable
(Enable) / Disable
Circular Recording
Enable
Enable
(Enable) / Disable
Split File Time (min)
10
15
(10) / 15 / 20
Mic
Enable
Enable
(Enable) / Disable
LED On/Off
On
On
(On) / Off
PIR Trigger****(4)
Off
On
Off
Voice-Trigger
Sensitivity***(5)
Disable
Disable
High / Medium / Low / (Disable)
Vibration Standby Mode(7)
Power Saving
Power Saving
Fast Wake Up / (Power Saving)
Motion-Trigger
Sensitivity***(8)
Disable
Disable
High / (Medium) / Low / Disable
Ext-Trigger In Contact
Type***(9)
Disable
Disable
Normal Open / Normal Close / (Disable)
Aux-Trigger Out
Disable
Disable
Normal Open / Normal Close / (Disable)
Auto On/Off
Disable
Disable
Scheduled Recording / Car-activated
Recording / Car-stop Recording / Car-
activate or Car stop Recording / (Disable)
Note: If a recording has started, you cannot switch between modes.
When the QSD-722 is connected to a car through the 5V car adapter and the auto on /off mode is selected:
Car-activated Recording: Auto-starts recording once the car is started, auto-stops recording when car is
stopped.
Car-stop Recording: Auto-starts recording when car is stopped, auto-stops recording once car is started.
Car-activated and Car-stop Recording: Auto-starts recording once car is started and continues to record even
when the car is stopped. The camera needs to be turned off manually to fully turn off the camera.
* For the longest recording time, set Video Quality to Low, Resolution to 640x360 and Frame Rate to Low.
This way the QSD-722 can act as a digital voice recorder.
*** If this triggering is enabled, the QSD-722 will record for 10 seconds after the device is turned on. Then it
will go into standby. If there is a trigger, it will keep recording until there are no further triggers. After that,
it will record for 2 more minutes and then standby again.
