background image

 

                                                                       

QCA Spa Light 

All equipment Modules have a receptacle, located on the 
Equipment Module. This receptacle is provided for the 
connection of the spa light. 

 
Your QCA Spa has a standard 12v light. The spa light 
may be turned ON or OFF by pressing the LIGHT button, 
located on the spa side control. The light will 
automatically turn off after 4 hours. 

 
Spa Light Lens Installation 

Colored lenses are included with the spa light. To install 
or remove lenses simply push ON or pull OFF of the spa 
light, as shown below. 

Spa Light Bulb Replacement 

To replace the spa light bulb; turn ALL power to the 
Equipment Module OFF. Locate the rear of the spa light 
and remove the bulb socket by rotating socket counter 
clockwise 1/8 turn and pulling on the socket (not the 
wires), as shown below. Pull the bulb from the socket and 
replace by reversing the above steps. 

 

 
CAUTION:

 

The replacement bulb must be the same 

rating as the factory installed bulb. 
 
Spa Care and Maintenance 

It is recommended to completely drain the spa at least four 
times a year. Otherwise, the water becomes chemically 
"saturated" and no longer responds to regular chemical 
upkeep. The spa should also be drained before long 
periods of disuse, or for equipment repair. 

 
Draining of Water 

Because of the small water volumes involved with spas, 
sometimes it is much simpler and less expensive to drain 
the water than to adjust the water chemistry with chemical 
additives. To drain the spa, shut off the main breaker to 

your spa equipment pack.  A drain fitting (if equipped) is 
provided on cabinet panel. Remove plug from drain. 
Attach garden hose to drain adapter and lay out garden 
hose to the location where water is to be drained. Screw 
drain adapter into drain fitting spa will automatically drain 
by gravity. 

 
 

 

Optional Draining of the Water 

 

Simply siphon water from spa with garden hose 

 

A sump pump may be used to pump water from 
spa. 

 

Use a wet/dry vac to remove the remaining amount 
of water. 

 

Refilling your Spa 

1.   Be sure the main breaker to your spa equipment pack 
is off. 
2.   Fill spa thru the filter housing with water to proper 
level.. 
3.   Turn power back on, spa will automatically start to run 
and heat water to set temperature. 
 

Your Water Care Program 

Before adding chemicals to your spa, do a full water 
analysis with a test kit or ask your QCA Spa dealer to 
conduct the water test for you.  (The following is an 
illustration of the steps taken when Bromine is the water 
care program.   You may choose to use an alternate water 
care program with different chemicals. Please consult 
your QCA Spa dealer for proper water care instructions.) 

 

 

Step 1:

 Always have the circulation system running 

before adding any chemicals. As you fill your spa 
to the level recommended by the manufacturer, add 
cleaning agent to prevent mineral staining and to 
protect equipment against scale and corrosion. 
Circulate for one hour. 

 

Step 2:

 "Balance" the water so that it is neither alkaline   

(scale forming) nor acidic (corrosive). Balanced 
spa water should be 7.2- 7.8 on the  pH scale, with 
total 7.3 alkalinity (the measure of the ability of 
water to resist a change in pH) in the range of 80-
120 parts per million (PPM). 

 

 
A.   If pH is lower than 7.2, add pH UP 
B.   If pH is higher than 7.8, add pH DOWN 
C.

 

If total alkalinity is below 80, add 

      ALKALINITY UP. 
 

Step 3:

 Shock treat the water with non chlorine shock to 

destroy any organic contaminants that may have 
accumulated in the spa during filling. 

 
Step 4:

  Prepare your disinfectant dispenser or feeder for 

use according to directions. A bromine residual of 
2.0 - 4.0 PPM, as determined by your test kit, should 
be maintained at all times. Directions for using the 
bromine are indicated on the float ring. 

 
We suggest you follow a regular maintenance program to 
keep your spa water fresh and crystal clear. 

 

 
 
 
 
 
 
 
 

Содержание VS300 PAK











Отзывы: