10 |
Fixing Slide Rail Using Rivet
— Assembly |
Flextrac Series
Fixing Slide Rail Using Rivet
ASSEMBLY
CARET-LEFT
Drill two holes near the
beginning of each slide rail
section. Use the drill fixture to ensure
clean-cut holes and correct location
of the holes. The holes must be at the
beginning edge of the joint piece, in
the direction of travel, to hold slide
rail in place when conveyor is in use.
Use a well-sharpened drill bit.
1
Use a countersink to
deburr and countersink
the holes. Also ensure no metal
filings are left underneath the
slide rail.
2
Insert rivets in the holes,
using rivet crimping tools
to crimp the rivets
3
Check that rivets do not
protrude over surface
of slide rail. Check both top and
bottom surface of slide rail for
protruding metal.
4
Keep a distance of
approximately 30mm
between rivets and idler unit in
case the idler end must be removed
after conveyor system assembly.
5
Applicable for MS2 and MM3 only
MS2 SR 25 Slide Rail Shown
comment-alt-exclamation
