QT-5100A Module
Revision: 1
QT-5100 Module Rev 1-march15.doc
Page 5 of 8
Q5X Systems, Inc. 2018
a standalone unit that is ready for integration into final form factor with the limitation for mobile use as
specified in RF Exposure compliance. For proper usage of the module, the module integrator must
ensure that the input power and input audio signal do not exceed the specified limits as outlined in the
specification section. Failure to do so will result in damage to the module.
Final product(s) after integration with this module shall be tested to comply with all applicable FCC
requirements and Unintentional radiators (FCC section 15.107, 15.109 and ISED ICES-003) before
declaring compliance to Part 15 of the FCC Rules and ISED ICES-003.
The module integrator may not:
1)
Alter, modify or remove the module case.
2)
Make changes to the Circuit Card Assembly of the module.
3)
Remove, change or alter the integrated UHF antenna or the 802.15.4 antenna.
Failure to comply with these restrictions will result in violation of the FCC certification.
Labeling of the End Products:
The modular transmitter must be equipped with either a permanently affixed label.
The modular transmitter must be labeled with its own FCC identification number, and, if the FCC
identification number is not visible when the module is installed inside another device, then the outside
of the device into which the module is installed must also display a label referring to the enclosed
module. This exterior label can use wording such as the following: ‘‘Contains Transmitter Module” or
‘‘Contains “. Any similar wording that expresses the same meaning may be used.
Below are Sample Module and Product lables that must be used for the Module and the Product.
