Q-See QSNDVR9M, Руководство по дистанционному наблюдению

Страница: 31 / 33

(Y/N)”.Press “ Y ” key on keyboard or click “ Yes ” button to exit. Press “ N ” key on keyboard or click “ No ” button
to return to the main menu.
Attention : These two buttons do not appear at the same time. When “Disconnect” shows, it means the
net client is connected to DVR, when “Connect” shows, it means the net client is not connected.
3 Setting up the DVR for Remote Access
To access the DVR through a remote computer you need to make sure the default gateway on
the DVR is the same IP address as your router, and the first three sets of numbers of the DVR IP
address are the same as the first three sets of numbers of routers address. Example: if your router’s
default gateway is 192.168.1.1 then the default gateway setting in the DVR should be
192.168.001.001, and the first three sets of numbers on the DVR's IP address should be
192.168.001. The subnet on the DVR also needs to be the same as the router, example: if the
subnet on the router is 255.255.255.0 the subnet on the DVR needs to be 255.255.255.000. To get
the default gateway and subnet of the router go to a computer that is attached to the same router as
the DVR, click on the start button, then click on run, then enter cmd into the space and click on OK.
At the curser type ipconfig, the default gateway and subnet will be displayed. You would enter the
network setting on the DVR in the SETUP-NETWORK, TYPE>STATIC section.
31