MAX-FLO MY1-80 METAL & NON-METAL - Supreme Performance
Assembly, Installation & Operation Manual | www.qmax.com.my
3
READ ME FIRST - IMPORTANT INFORMATION
CHEMICAL REACTION DISCLAIMER
The user must exercise primary responsibility in selecting the product’s materials of
construction, which are compatible with the fluid(s) that come(s) in contact with the product.
The user may consult manufacturer and a manufacturer’s representative/distributor agent to
seek a recommendation of the product’s material of construction that offers the optimum available
chemical compatibility.
However neither manufacturer nor a gent shall be liable for product damage or failure, injuries,
or any other damage or loss arising out of a reac-tion, interaction or any chemical effect that
occurs between the materials of the product’s construction and fluids that come into contact
with the product’s components.
SAFETY PRECAUTIONS
READ THIS MANUAL COMPLETELY BEFORE INSTALLING AND OPERATING THIS PUMP.
FAILURE TO FOLLOW THESE PRE-CAUTIONS CAN RESULT IN SERIOUS INJURY OR
DEATH.
WARNING:
The pumps from this model are not intended to pump flammable or combustible
materials (consult factory).
WARNING:
Do not exceed maximum pressure stated on the pump serial number sticker. Pump
exhaust may be loud and contain particles. Wear appropriate ear and eye protection. In the
event of a diaphragm rupture material can be forced out of the air exhaust muffler. If product is
hazardous or toxic pipe exhaust to appropriate safe area.
WARNING:
Chemical Hazard. This pump is used for transferring many types of potentially
dangerous chemicals. Always wear protective clothing, eye protection and follow standard safety
procedures when handling corrosive or personally harmful materials. Proper procedures should
be followed for draining and decontaminating the pump before disassembly and inspection of
the pump. There may be small quantities of chemicals present during inspection.
WARNING:
Before maintenance or repair, close the compressed air supply valve, bleed the
pressure and disconnect air line from the pump. Discharge line may be pressurized. Any
pressure must be relieved before service.
CAUTION
1. To help avoid unnecessary damage to the pump, do not allow pump to run dry for long
periods of time.
2. Use only genuine Pump-Fit replacement parts to assure compatible pressure rating and
longest service life.
3.
If pump is used with materials that tend to solidify or settle pump should be flushed after
each use to prevent damage.
4. nstall the pump in a vertical position or the pump may not prime properly.
5. Re-torque all fasteners before operation. Creep of housing and gasket materials may cause
fasteners to loosen. Re-torque all fasteners to insure against fluid or air leakage.
6. Unpack the pump and examine for any signs of shipping damage. If damage is detected,
save the packaging and notify the carrier immediately.
