7
RINS 049 issue-1
5
CONTROLS AND FUNCTIONS
Volume Control
This is only accessible when the front cover has been removed and will only affect
the volume of the internal sounder together with any extension speakers. The volume
control is overridden when the panel is in an alarm state, and also if the the panel has
been set by the User code.
Chime
Chime function applies to day mode only and if selected will cause the panel to
generate a three-note sound when an entry/exit zone is triggered. This feature is to
inform the occupants of the building that someone has entered.
Latch
The latch facility is designed to be used with intruder detectors fitted with a latch
memory. This feature is very useful when more than one detector has to be wired to a
particularzone as it will show which detectors were triggered if an alarm occured. If
there has beenan alarm and latch memory was used, then when the panel is reset an
LED indication will be given at the relevant detector(s). Resetting of latch memory
requires the panel to be set again for not less than 5 seconds, and then unset.
Auto Rearm
After an alarm the panel will automatically reset itself when the bell timer has expired.
Any zones which still remain triggered at that time will be omited automatically.
Walk test
The walk test function verifys that all the intruder detectors on the alarm system are
functioning correctly. When the walk test mode is enabled any activated zone will
cause a chime and the LED display to indicate
10
6.11
Changing User Code
Enter
then
User code - 3 Bleeps
then
New user code - 3 Bleeps
then
New user code again - 3 Bleeps
The DAY led will flash when this function is entered and an acknowledge tone will be
sounded after each code has been entered. If an incorrect key is entered an error
tone will be given and the function ended.
6.12
System Test Mode
Enter
This function performs a number of tests which are listed below.
The next test is selected by pressing any numeric key.
To exit system test mode press the key again.
Test
1) All LEDs are switched on
2) The strobe is switched on.
3) The bell is switched on
4) The internal sounder is switched on
6.13
Walk Test Mode
Enter
When the walk test mode is enabled any activated zone will cause a chime and the
LED display to indicate.
To exit walk test mode press the
Key again
7
LED FUNCTIONS
Supply light on
:
Indicates there is mains on the system
Day light on
:
Indicates the system is unset. (Day
mode)
Zone light on
:
Indicates an Alarm activation
Tamper light on
:
Indicates a Tamper alarm
P.A light on
:
Indicates a Personal Attack activation
Tamper light flashing
:
Engineer mode
