EURO 46 Installation Manual
Page: 9
3.1
Technical Specification
Programmable
Outputs
Power Rating
Normal State
Active State
PGM 1
Relay, 3A, max 30V Changeover NC & NO Changeover NC & NO
Speaker
16 ohms
No tones
Repeat RKP tones & internal sounder
Strobe Output
500mA
12v
0v
Bell Output
500mA
12v
0v
XPGM 1 (Input 7)
50mA
Floating
0v
XPGM 2 (Input 8)
50mA
Floating
0v
ATE Outputs
2mA
5v
0v
All outputs are programmed in "CHANGE OUTPUTS" in the Engineer menu.
Input Resistance
1k / 1k DEOL Range
4k7 / 2k2 DEOL Range
4k7 / 4k7 DEOL Range
Normal
0k5 to 1k4
1k4 to 2k9
3k7 to 8k3
Burglary Alarm
1k5 to 5k9
4k2 to 7k8
8k4 to 10k2
Fault
6k to 8k1
8k to 11k3
10k3 to 14k9
Masking (6k8)
8k2 to 17k
11k6 to 22k
15k to 22k
Tamper
<0k5 or <17k
<1k4 or >22k
<3k7 or >23k
All inputs are programmed in "PROGRAM INPUTS" in the Engineer menu.
Fuses Value Type
Bell Fuse for bell terminals
F800mA quick blow 250V
Glass
Aux Fuse for aux terminals
F800mA quick blow 250V
Glass
RS485 Bus Fuse for bus terminals
F800mA quick blow 250V
Glass
Battery Fuse for battery terminals
T1.6A slow blow 250V
Glass
230V Mains Fuse for mains terminals T500mA H anti-surge slow blow 250V
Ceramic
Panel Power Supply Output
Nominal
Range
Output Voltage
13.7V DC
10-15V DC
Output Current
EURO 46S
1A Continuous
1.5A peak, during battery charging
Output Current
EURO 46L
1.5A Continuous
2.0A peak, during battery charging
Power Supply Type A.
Maximum output peak voltage: Max 100 mV
SD Voltage which the deep discharge protection function will operate at: 10.5V
Over Voltage Protection Trigger Voltage: 18V
NOTE 1
. EURO power supplies are NOT designed for use with multiple batteries connected.
NOTE 2
. System load should not exceed the panel power supply output shown above or the maximum load
supportable by the battery for the specified backup time, as in the table shown below.
NOTE 3
. The power ratings are based on battery shown in table – but ANY battery capable of supporting the
system load for the required time may be used without affecting these ratings.
Panel Power Supply Input
Nominal
Range
Mains Supply Voltage AC
230V AC at 50Hz
-15% +10%
Transformer Rating EURO 46S
18VA
18V at 1.0A
Transformer Rating EURO 46L
45VA
18.5V at 2.5A
Battery Charging Specification
Float Voltage
13.8v DC
Control Panel Type
Battery low voltage cut off
10.5v
Standby battery capacity
current
300mA (3A to 7A)
Recharge time
<24 Hours
Standby battery capacity
current
700mA (8A to 17A)
Содержание Castle EURO 46L
Страница 41: ...EURO 46 Installation Manual Page 41 7 8 4 EURO OEM8R8T Output Connections ...
Страница 50: ...EURO 46 Installation Manual Page 50 ...
Страница 51: ...EURO 46 Installation Manual Page 51 ...