ezPyro
TM
Flame Detection Evaluation Kit User Manual
Page 3 of 18
© Copyright Pyreos Ltd. 2020
ezPyro
TM
User Manual Rev. 3.1
1
Introduction
This document describes the ezPyro
TM
Flame Detection Evaluation Kits and the related software for both kits. The
purpose of these kits is to enable engineers and technicians to carry out simple and effective evaluation of ezPyro
TM
flame sensors, experiment with a sample Flame Detection algorithm, and to capture measured data to a PC.
The kits are based on the ST microelectronics STM32F303K8 microcontroller.
Please note: The software discussed in this document can only be used with the ezPyro
TM
Flame Detection Evaluation
Kits.
2
Getting started
2.1
Hardware Variations
There are 2 variations of the hardware that can be used with the ezPyro
TM
Flame Detection software: the 4-sensor
SMD and the 3-sensor TO.
Figure 1: ezPyro
TM
SMD (left) and TO (right) Flame Detection Evaluation Kits
2.2
Kit contents
1.
ezPyro
TM
- Prototype Flame Sensor Demonstrator Kit (SMD or TO)
2.
Micro USB-to-USB cable
3.
ezPyro
TM
Flame Detection software (Setup file included in software package)
4.
USB drive with software and documentation
2.3
Minimum system requirements
1.
Microsoft® Windows PC (all versions supported currently)
2.
GB of RAM
3.
450 MB of available hard-disk space for installation, additional free space required for storing CSV files
4.
1024x768 display (1280 x 1024 recommended)
5.
Local administrative rights to install device drivers
6.
.NET Framework 4.5
7.
1 free USB port
