PRECAUTIONS AND MAINTENANCE
.1.This unit is designed for negative ground operation only. The equipment can
be used safely, if the negative terminal of the battery is connected to the
vehicle metal work.
2.Do not use speakers of impedance less than 4 ohms; and allow the speaker
wires to be shorted together when the unit is switched on.
Otherwise it may overload or burn out the power amplifier stage.
3.If the car interior is extremely hot, as after being parked in the sun, do not use
the player until the car has been driven for a while to cool off the interior.
4.Take care of your tape cassette to preserve the quality of the recordings. Do
not allow them to be exposed to direct sunlight. Store them in a place
protected from dirt and dust and avoid handing with greasy or oily hands.
Also, keep the away from magnets, and motors of the permanent magnet type.
5.It is not advisable to use cassette tapes longer than C-60(30 minutes per side)
in automobile players, since the tape is too thin and tends to become easily
entangled. Always remove cartridge from your tape player as soon as play is
finished.
6.The capstan and tape head should be cleaned about once every six months
with a soft cloth or cotton-wool swab, moistened with alcohol.
This will serve to maintain the richness and clarity of sound, and prevent loss
of volume. Do not use a screwdriver, or ferrous metal rod , in carrying out the
above cleaning. See illustration.
7.A loosely wound cassette tape will get damaged. Prior to using such tape,
tighten it in a manner as guided by Fig. 2.A carelessly would cassette tape will
cause unnecessary pressure on the tape resulting in the cassette springing out
while the tape is running .For prevention, rewind the tape through fast for
warding or rewinding.
BASS CONTROL
1). Press the SEL button to select the bass mode until BAS appears on the
display.
2). Press + or - to adjust the bass effect.
TREBLE CONTROL
1). Press the SEL button to select the treble mode until TRE appears on the
display.
2). Press + or - to adjust the treble effect.
BALANCE CONTROL
1). Press the SEL button to select the balance mode until BAL appears on
the display.
2). Press the + button or - button to increase or decrease the sound level
of left or right speaker.
19.RELEASE BUTTON
Press it to detach the front panel from the unit and you can take
away the front panel.
20.ST BUTTON
Press it to select stereo or mono sound mode.
21.EJECT TAPE BUTTON
Press it to eject the tape.
22. REW/FF PROGRAM BUTTONS
During tape playing mode, press one of them to fast rewind or for-
ward the tape, then press them together at the same time to stop
fast march. During tape playing mode, press them together at the
same time switch from one side of the tape to the other side.
23.
24.TAPE COMPARTMENT
25.
RESET BUTTON
Press it to rehabilitate the distorted program.
FLASHING LAMP WHEN TAKE OUT THE FRONT PANEL
FADER CONTROL
1). Press the SEL button to select the fader mode until FAD appears on
the display.
2). Press the + button or - button to increase or decrease the sound level
of the front or rear speaker.
7
4
