5
DEFAULT RESET
To reset all programmable features to their
factory default settings:
1. Turn on ignition.
2. Within 5 seconds, press valet switch 5
times.
• The horn will provide a long chirp, to
indicate entering program mode.
3. Press transmitter button 3.The LED will
flash 3 times, pause then continue
flashing. All programmable features will
be reset to the default position.
ADDING / DELETING REMOTE
TRANSMITTERS
Adding new transmitters to the system will
automatically delete all other remotes that
were previously operating the system.
NOTE:
You must code all desired remotes
at this time.The unit can learn a maximum of
three transmitters.
To enter Code Learning Mode:
1. Turn ignition key on, off, on, off, on and
leave on within 5 seconds.The horn will
chirp (if installed) and the LED / parking
lights will flash once.
2. Press and hold valet switch for 3
seconds.The horn will chirp and the LED
/ parking lights will flash 3 times.
3. Release the program switch.
4. Program all desired remotes by pressing
button 1 on each of the transmitters.
The parking lights will flash after the
system has learned each remote control.
5. Turn ignition key off. Remotes are now
programmed to the system.
853 new.qxd 3/15/2004 12:44 PM Page 5
