2
REMOTE CONTROL
Before use remote control, you have to install two “AAA” battery (not included)
1. CD door OPEN/CLOSE button
2. STOP/CD/USB button
3. RECORD button
4. PLAY/PAUSE button
5. BACK- button
6. PROGRAMME button
7. NUMBER button
8. DELETE button
9. button
10.
NEXT+ button
11. FOLDER- button
12. MODE button
Remark: When the battery runs low, the distance at which the remote control will operate is greatly reduced
and you will need to replace the battery.
USING THE REMOTE CONTROL
1. To use the remote control, point it at the remote sensor and press the button gently but firmly. Since
the remote control range is reduced when the unit is used at an angle, try to aim it directly at the
remote sensor.
2. Do not expose the remote sensor to strong light (direct sun shine or artificial light) and make sure that
there are no obstacles between the remote sensor and the remote control.
GETTING STARTED
CONNECTING THE AC POWER CORD
Remark: As this product is dual voltage 110/220V, before connecting the AC power cord, please check the
voltage at back of the unit which voltage it was set.
1. Unwind the AC power cord and connect it to a household 110V~ 60HZ or 220V~ 60HZ AC outlet.
OPERATING THE RADIO
AM/FM TUNER
1. Set the FUNCTION selector (20) on the RADIO position.
2. Select the desired frequency with the BAND SWITCH(23)
3. Tune in to the desired radio station by turning the Tuning control knob (25).
4. Adjust the /- (28)to the desired level.
5. Set the FUNCTION selector (20) on OFF position to turn off the radio.
Hints for best reception:
-
AM: The receiver has a built-in AM antenna. If AM reception is weak, slightly turning or changing the
position of the unit will usually improve the AM reception.
-
FM: The receiver has a built-in FM antenna (34) hanging at the rear cabinet. This wire should be fully
unravelled and extended for best reception.
