TROUBLE SHOOTING
Please refer to this chapter when you encounter a problem list prior
to contacting your dealer.
Problem: Possible solution(s):
No power
1, The projector donot connect the power cable
2, Donot open the projector .
3, Fuse broken
Remote doesn't operate
1,Projector turned on to quickly after
last turn off (needs 5 minutes).
2,Batteries defect.
3, Aim remote correctly at IR receiver.
No image
1, Please remove the len cap at first
2, Projector turned off.
3, Selected the wrong input signal.
4, the mainboard are broken . Please
Replace this mainboard.
Trouble Shooting
About the installation
In order to improve the projector service life,
It shouldnot place in a wet and
ventilation condition
Donot put the projector under the sunshine
directly
Projector working temperature: 0
+70
Projector store temperature : -20
+70
Fans will adjust the temperature
It is controlled by system
when the projector work,
the fans turn slowly or quickly
so the fans noise are different
But it is normal
when the projector work ,donot pull out the pwer cable
If the fans stop to work,it will cause
the projector interior temperature very high, so it may damage the projector.
Warning
Caution
Donot block the ventilation-window
of projector
If the projector interior temperature
are too hot , the machine will be shut
off automatically.This is hot -
protected system.
So please clean the filter of projector
per month . It is very important.
Donot let the dust cover the filter.
About Open and close the projector
when open the projector ,connect
the power cable and press the "power"
key on the panel .the projector will
work ,but the lamp will be bright more
and more .After 5 minutes, the lamp wor
normally
when close the projector , press the powe
key again . And then the lamp shut off.
But the fans still work until 5minutes late
When close the projector ,donot pull out
the power cable directly . After 5minutes
the projector will shut off automatically.
Содержание PRJHD66
Страница 1: ... ...
