Pyle PLCD65WXMU, Руководство пользователя

Страница: 9 / 16

9
OPERATION
SWITCHING ON/OFF THE UNIT
Switch on the unit by pressing any button
(except button (7) and button (4)).
When system is on, press
POWER button
(9) to turn off the unit.
FACEPLATE RELEASE
Press button (7) to detach the removable
faceplate.
SOUND ADJUSTMENT
Press PUSH SEL button (10) shortly to
select the desired adjustment mode.
The adjustment mode will change in
the following order:
By rotating the AUDIO knob (10) clockwise
or counter-clockwise, it is possible to
adjust the desired sound quality.
Press and hold the
SEL button (10) for
several seconds to enter into the selection
for the situation of beep sound, then rotate
the
AUDIO knob (10) clockwise or
counter-clockwise to select as follows:
- BEEP 2’nd mode:
The beep is only generated when
all allowed double function button
is pressed long (several seconds).
e.g.
When preset button is pressed.
When
BND/LOU button (13) is
pressed.
When
AS/PS button (18) is pressed.
- BEEP ALL mode:
The beep is generated when every key
is pressed.
- BEEP OFF mode:
The beep is disabled.
LOUDNESS
Press BND/LOU button (13) for several
seconds to reinforce the bass output.
Press it for several seconds again to
release this function.
SET THE CLOCK
Press the DSP button (15), the clock is
shown on the display. Then hold down
the button until the clock flashes. Then
press the
TUNE/TRACK button (17) to
change hours or TUNE/TRACK button
(16) to change minutes.
VOL BAS TRE BAL FAD
(Volume) (Bass) (Treble) (Balance) (Fader)
MUTE
Press MUT button (3) to mute down the
sound instantly. If any button is pressed
in the mute state, the mute state is
released.
EQUALIZATION
Press and hold EQ/REC button (19) for
several seconds to turn on equalization
function and to select desired audio mode.
There are five kinds of mode as below:
LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated
functions on the display (8).
REMOTE SENSOR
Point the remote control handset to the
remote sensor
IR (11). Press the function
keys on the handset to control the system.
ESP FUNCTION
If the unit has the electronic shockproof
function, it can be shockproof about
several of seconds.
RESET FUNCTION
RESET
button (12) must be activated with
either a ballpoint pen or thin metal object.
The
RESET button is to be activated for
the following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
Note: If press RESET button (12), the
unit can’t work yet, please use a cotton
swab soaked in isopropyl alcohol to clean
the socket on the front panel.
RADIO OPERATION
• SWITCHING TO RADIO MODE
Press MOD button (6) shortly to
select radio mode, the radio mode
appears in the display together with
the memory band and frequency.
• SELECTING THE FREQUENCY
BAND
At radio mode, press BND/LOU button
(13) shortly to select the desired band.
The reception band will change in the
following order:
FM1 FM2 FM3 AM
FLAT CLASSICS POP M ROCK M DSP OFF
BEEP 2ND BEEP ALL BEEP OFF