Pyle Pro PYD-1002, Руководство пользователя

Страница: 5 / 15

Presetting the Controls Before Use
Since sudden high output levels from your Pyle Pro mixer can damage not only audio devices connected
to the mixer output but your hearing as well (especially if you are using headphones), please adjust
the mixer’s controls BEFORE connecting AC power or turning on the unit.
Set up the mixer controls like this before you start:
Pyle Pro Mixer Owner’s Manual - 3
Playing the Mixer’s Output Signal
To record the mixer’s output signal, connect audio patch cords (not supplied) from the mixer’s REC
(Record) L and R jacks to your tape deck’s left and right input jacks.
To monitor the mixer’s output on a second set of speakers in the DJ booth (or in a remote location),
connect an audio patch cord from the mixer’s ZONE L and R jacks to the additional amplifier’s left
and right input jacks.(PYD-1005)
Power On/Off
Balance
Tone Controls, Treble, Mid and Bass
MIC 1/2, CH 1/2/3, Master and Cue Levels
Crossfader
OFF
MID
0
0
CENTER
CONTROL SETTING
Connecting the Outputs
After presetting the controls (above), you can then connect the mixer’s output jacks to the output
devices’ input jacks. Before connecting these devices, however, be sure to preset their controls to
avoid any damage to your equipment due to unexpected high output levels.
Set the output devices’ controls like this before you start:
Tape Deck
Amplifier/Receiver OFF
OFF
FLAT
OUTPUT DEVICE SETTING CONTROL
POWER
POWER
TONE
To play the mixer’s output signal through your speaker system (for events such as parties, dances,
conferences, etc.) connect an audio patch cord (not supplied) from the mixer’s MASTER L and R jacks
to your receiver’s left and right input jacks. This mixer permits you to choose cables with either RCA
jacks or 1/4” jacks for this connection, but do not use both sets of jacks simultaneously.
Recording the Mixer’s Output Signal
Monitoring the Mixer’s Output signal in the DJ Booth