www.PyleUSA.com
7
How to replace the preset radio stations?
• Use the remote control to set the radio stations.
• Use button of the front panel set the radio stations.
NOTE:
The preset stations can't be deleted, BUT CAN BE REPLACED.
Operations Steps
1. Rotate the input selector switch to the
BT/MP3/AM/FM/OPTI/COAX
position.
2. Press the Mode key of the front panel or remote to select AM/FM.
3. /
:
Press the button to adjust to your favorite station number, then,
press and hold this button to auto scan the programs downward or upward,
It will not stop until the tuner is found, and the tuner will automatic replace
your favorite station number.
In this way, you can replace the preset radio stations.
SAFETY INSTRUCTIONS
1. Make sure that all connections are properly connected and the main
volume is set to minimum level before turning
ON
the unit.
2. When more than one pair of speakers are used, (specially the main
speaker output) make sure that the speakers used are of the same wattage
and impedance, otherwise the unit maybe damaged under high power or
long term operation.
3. To avoid humming sounds and unwanted noise, make sure that all the
wires are properly inserted
4. For speaker cords, strip off the vinyl coating and twist the wire tip.
Push down the pink jack or loosen the screw terminal, before inserting the
wire tip, then fasten it and tighten the screw. Be careful not to let the wires
stick out ofthe terminal otherwise this may cause a short circuit when
wires of different terminal contact each other.
5. After the unit is turned
ON
, adjust the main volume to the desired level
same with the bass and treble volume, etc.
