CONNECTIONS
E Q
TAP E
TU NE R
P H ON O
C D
TU NE R
P LAY
R E C
TAP E
P LAY
R E C
E Q
C D
L
R
RE MOT E S YST EM
_
A U D I O
L
RIGHT
LEFT
_
AV1
AV2
L
R
INTEGRATED CIRCUIT
AC 220V - 230V ~50Hz
S P E A K E R S6 ~ 8
Ω
GN D
75
Ω
FM
AM
Loop
REMOTE SYSTEM
TO AMP
OUTPUT
ANTENNA
TUNER
INTEGRATED CIRCUIT
AC 220-230V~50Hz
POWER CONSUMPTION: 10W
RISK OF ELECTRIC SHOCK
DO NOT OPEN
TU
FM Antenna (75 )
Ω
AM Loop Antenna
* Instructions and requirements indicated may vary to some extent depending on sales area, local law and regulations.
Connection precautions
* When connecting or re-locating the unit, be sure to turn the power off or disconnect the power cable.
* Check the left and right channels and align them correctly (L to left and R to right.)
Connections to amplifier
The supplied pin-plug cables should be used for connection between the unit’s rear panel OUTPUT terminals and your
amplifier’s TUNER terminals. Make sure not to confuse the left and right cables in connection.
FM antenna connection
Use FM 75-ohms terminals when connecting a 75 ohms coaxial cable from an outdoor antenna.
AM loop antenna connection
Connect the cord of the accessory AM loop antenna to the AM LOOP antenna terminals, and attach it to the accessory
antenna holder.
Attach antenna holder to a wall with the range of the loop antenna cord. When tuning into AM (MW, LW) stations, move
the antenna to the left or right and set it in the direction which yields the optimum reception.
* AM (MW, LW) reception is not possible with the loop antenna detached. Even if n outdoor AM antenna is erected, keep
this loop antenna in place.
* Do not bring the power cord or the speaker cords near the loop antenna since noise will be generated.
* Do not bring the loop antenna near the display, otherwise it will affect the reception.
Содержание PT652T
Страница 1: ......