5
4. Assembling The Body
i. Output Jack (Part C)
The cavity for the output jack is
located on the lower right hand side of
the body. A ¼” hole has been drilled
to connect the output jack cavity to
the pickup cavity. Run the two wires
through this hole and attach the jack
to the body using the two provided
screws.
ii. Spring Claw (Part G)
Turn the body over to attach the
spring claw. The ground wire that has
been soldered to the spring claw
should be directed through the hole in
the cavity so that it enters the pickup
cavity.
iii. Pickguard Assembly (Part D)
The three wires from the pickguard
assembly must be connected to the
three wires that you have already fed
into the pickup cavity. Each wire has
a mini plug in its end. First slide back
the shrink tubing and plug white to
white, black to black, and blue to
blue. Carefully slide the shrink tubing
over the connectors. Heat the tubing
with a match to seal the connectors.
Attach the pickguard assembly to the
body with the screws provided.
