www.PyleUSA.com
7
www.PyleUSA.com
8
SYSTEM CONNECTIONS
1. Receiver Power Connection:
Connect the DC connector of supplied AC/DC
adapter Into the DC power input of receiver. Plug the AC Input connecter
into an AC120/60Hz or AC220V/50Hz outlet. (Shown as below)
2. Antenna:
Keep the position of antenna at a 45 angle from vertical.
(Shown as below)
3. Audio Connection:
Connect the corresponding output of receiver by
supplied 1/4w phone jack audio cable or your XLR cable to the Input of
power amplifier, mixer.
TROUBLESHOOTING
PROBLEM
INDICATOR STATUS
SOLUTION
No Sound
No Sound
No Sound
No Sound
No Sound
Sound level differs from
the level of a cabled
Instrument.
Sound level differs from
the level of different
guitars
Distortion level increases
gradually
Bursts of noise or other
audible radio signals
present
Momentary loss of
sound as transmitter is
moved around
performing area.
Receiver signal
indicators A/B lights
glowing
Receiver signal
indicators A/E lights
glowing
Signal indicators A/B
lights ON
Receiver signal
indicator A/B lights OFF
when sound is lost
Red transmitter
indicator is not
flashing
Red receiver POWER
light off
Receiver signal
indicators A/B lights
off. Transmitter and
receiver POWER lights
glowing
Receiver signal
indicators A/B lights
glowing
Red transmitter
indicator is flashing
Slide transmitter POWER ON/OFF switch
to ON position. Make sure battery is
inserted properly, observing battery (+/-).
If the battery is inserted properly, replace
with fresh battery.
Slide transmitter MUTE/ON switch
to ON position
Make sure AC adapter is securely
plugged into electrical outlet and into DC
input connector. Make sure AC electrical
outlet works and supplies proper voltage
Trun up receiver volume control. Confirm
that the output connections from the
receiver to the external equipment are
secure
Confirm transmitter and receiver~
frequency match. Move transmitter
closer to receiver.
Adjust transmitter gain level to
compensate.
Adjust receiver volume as necessary
Readjust transmittergain level to
compensate differences in guitar outputs
Replace transmitter battery
Identify potential sources of interference
(other RF sources) and turn OFF, remove
or use a wireless system operating on a
different frequency
Reposition receiver and perform
walk-through again. If audio dropouts
persist, mark “dead” spot-and avoid them
during performance.
Receiver signal
indicators A/B lights
and transmitter LOW
BATTERY light glowing