BODYPACK TRANSMITTER
--3--
1.Slide up the battery cover in the front of the body pack as per above sketch map. Install the provided 9 volt battery and the
battery cover. Make sure to connect with the correct polarity.
2.Move power switch to ON position. Power LED indicator will flash once and then go off. This indicates correct operation.
If power LED indicator lights red, this indicates the battery is low. Please replace with new battery.
3.Move power switch to centre to mute the microphone.
4.Adjust the volume control to you get the sufficient sound from your speaker.
5.If the microphone is not going to be used for a long period of time, please take out the battery to prevent damage by battery
leakage.
Headset MIC
Lavalier MIC(Optional)
OPEN
9
V
B
A
T
T
E
R
Y
C
L
O
S
E
O
P
E
N
OPEN
B
A
T
T
E
R
Y
C
O
V
E
R
ON/OFF LED
VOLUME CONTROL
(HIGH/LOW)
MIC IN
BODYPACK TRANSMITTER
--4--
1.Switch on the wireless microphone receiver unit by pressing the POWER switch and the POWER light will illuminate to show
the receiver unit is working.
2.Fully extend the aerials to the maximum height.
3.Switch ON the transmitter. Power LED indicator will flash once the go off. When the microphone is ON, the receiver RF
indicator will light.
4.Adjust the volume and tone levels of your amplifier system as well as the receiver & the body pack as required.
5.When the transmitter is not going to be used for a long period of time, please take out the battery from transmitter.
Note that switching the microphone on and off can cause interference that will be heard if the microphone volume level of the
amplifier system is still set high.
ANT.B
BALANCED
AF.OUT
MIX
ANT.A
DC 12V
MIN
MAX
MIN
MAX
AUDIO
POWER
SIGNAL-A
P R O F E S S I O N A L
P D W M 2 7 0 0
W I R E L E S S M I C R O P H O N E
SIGNAL-A
AUDIO
VHF
R
