Page 3
Page 8
General Controls
1. OPEN BUTTON
To remove the front panel from the main body, press the OPEN key. And the
anti-theft LED indicator will be flashed all the time till the front panel be refixed
into the main body.
2. POWER ON/OFF
In power off (ACC on) mode, turn on the unit by pressing the POWER button
on the front panel; It also can turn on the unit to insert a disc into CD slot. It
will start play the first track on the current disc.
Press the POWER button short to turn off the unit.
3 & 4.VOLUME UP(+)/DOWN(-) BUTTONS
Press the volume
UP(+)
or
DN(-)
button short or hold to raise or lower the
volume level during playback. The both buttons are also used to adjust the
settings for Bass, Treble, Balance, Fader, when you are in those audio modes.
5. MUTE ON/OFF BUTTON (Only for radio mode)
This button serves to switch the MUTED state on/off during RADIO mode.
Press the mute(MUTE) button short to suppress the speaker temporarily.
Press it again to resume listening.
6. AUDIO FUNCTION AND MENU SELECT/ADJUST
1)Audio mode select and adjustment:
Press the SEL button repeatedly to cycle through four audio modes:
-> VOLUME ->BASS ->TREBLE -> BALANCE -> FADER
After selecting a certain audio mode, you can adjust the setting for Bass, Treble
Balance, fader by pressing the
UP(+)
or
DN(-)
button.
The control mode of E.VOL is operated with following numeric display.
- VOL: (MIN)00, 01,......45, 46(MAX).
- BASS/TREB: -6, -5,...,00,...5,6
- BAL: 9L, 8L,...,00,...8R,9R
- FAD: 9F,8F,...,00,...8R,9R
In each mode, the waiting time is about 3 seconds, and the waiting time is
over, it returns to the last display mode of RADIO or CDP mode.
7. EQ BUTTON
Press the EQ button short to access the p
reset equalizer mode. Press it
repeatedly
to choose EQ OFF, or 4 preset equalizer curves: FLAT, CLAS,
ROCK, POP. The audio output will change correspondingly.
8. LOUDNESS BUTTON
Pressing and holding the LOU button to enhance the bass output when low
volume level. Pressing and holding it again to cancel loudness effect.
TROUBLE SHOOTING
PROBLEM
No power
Disc cannot
be loaded or
ejected
CAUSE
The fuse is blown
Another CD is present in the
player
Disc incorrectly inserted
upside-down
CD is extremely dirty or
defective
Temperature inside the car is
too high
Condensation
Volume is too low
No sound
Sound skips
The antenna cable is not
connected
Insert the antenna cable firmly
The radio does
not work
Wiring is not properly
connected
The installation angle is more
than 30 degrees
CD is extremely dirty or
defective
Clean the CD or try a different CD
Adjust the installation angle to less
than 30 degrees
Adjust volume to desired level
Check the wiring connection
Turn off the player for at least an
hour, then try again.
Give enough time for the temper-
ature in the vehicle to cool down.
Clean the CD or try a different CD
Insert the CD with label face up
Remove CD in the player, then insert
a new one with label face up
Replace the fuse
The car ignition is not on.
If the power supply is properly
connected to the car, switch the
ignition key to " ACC "
SOLUTION
Before using the check list please make all the connections first.
If you still have questions after going through the checklist, please consult
your local customer service representative.
