wiring tips
8
Signal Processor enclosure
Mounting Bracket
4 x 12 mm
self-tapping screw (2)
4 mm spring
washer (2)
4 mm plain
washer (2)
4 x 6 mm machine screw (4)
dashboard
When making electrical
connections to your amplifier,
please observe the following:
Connect 12V DC from a constant battery source to a +12V slip-on spade terminal and install
a one (1) amp fuse in line.
Connect the signal processor’s GROUND to a good chassis ground, near where the unit is
mounted, or to the case of the head unit.
Connect the signal processor’s REMOTE TURN-ON lead to the remote turn-on lead out of
the head unit, and install a 1/2 amp fuse in line. (A relay should be used if turning on more
than one component, such as EQ’s, crossovers or amplifiers.)
Connect stereo RCA cables from the head’s left and right front outputs to the left and right
inputs of the signal processor.
Connect stereo RCA cables from the left and right outputs, (and low, mid and high outputs
if applicable), of the signal processor to the left and right inputs of your amplifier(s) or
additional signal processor(s).
Turn the unit on, and adjust the input gain on the signal processor to match the output of
the head unit (1/2, or at center position, is about 1 V). Be careful not to overdrive the input
of your amplifier(s) or signal processor(s).
Adjust each of the crossover or equalizer controls to achieve the desired sound characteristics.
mounting
mounting and installation
ple730r
ple520p
Please take the time to install your
new Pyle Signal Processor
securely, according to this
diagram, using the hardware
provided.
This Half-DIN size unit can also
be installed in the dash adjacent
to the head unit, provided that
there is a slot available.
12V
RE
