PYI NRG MARINE SONIHULL MONO, Руководство по установке

Страница: 5 / 8

lOCatION OF tRaNsDuCeRs &
INstallatION OF the sONIhull CONtROl uNIt
LOCATION OF TRANSDUCERS
The following is a guide line for the best
location to install on your yacht. The pictures
are for illustration only as the transducers
will be mounted on the inside of the hull.
The aft transducer should be mounted
close to the center line of the hull in the
rear 1/3 of the boat in close proximity to the
propeller shafts, steering gear and trim tabs
to provide the best possible protection.
For the Duo, the front transducer should
be mounted approximately 2/3 of the way
along the boat, again close to the center
line of the hull.
For yachts over 60 feet please consult with
PYI Inc for advise on the best location for
the transducers.
For twin engine yachts we recommend
that a Duo system be installed, with one
transducer installed above close to each
propulsion unit, thus providing protection to
the stern drive itself as well as the hull.
INSTALLATION OF THE SONIHULL
CONTROL UNIT
Once the Sonihull system is installed you
will find that there is little maintenance
required due to the systems sophisticated
technology. Therefore your Sonihull Control
Panel can be installed out of sight, in a
cupboard or even in the engine room itself.
As with any electrical appliance it is wise to
check the system periodically to ensure that
the system is powered and working.
Find a suitable dry location above the water
line, with suitable access to either mains or
DC power. Please also consider that the
location should be suitable for access to the
transducers.
MAINS AC supply only. 100-240 VAC 50/60
Hz. Replace lid and plug into suitable AC
socket. If socket is not available please
consult a competent marine electrician to
carry out any electrical installation.
DC only supply. 12-24 V DC
SAFETY - ensure that the cables are
supplied via 5 amp fuse.