1. GENERAL DESCRIPTION
PX387 SwitchDimm DMX Controller is a device powered with safe voltage 12-24 V; however,
during its installation and use
the following rules must be strictly observed:
1. The device can be connected to 12-24 V DC (stabilised voltage) with current-carrying capacity
compatible with technical data.
2. All the conductors should be protected against mechanical and thermal damage.
3. In case of damage to a conductor, it should be replaced with a conductor of the same technical
parameters.
4. Connection of DMX signal can be made with a shielded conductor only.
5. All repairs, connecting and disconnecting of cables can only be made with cut off power supply.
6. The device should be strictly protected against contact with water and other liquids.
7. All sudden shocks, particularly dropping, should be avoided.
8. The device cannot be turned on in places with humidity exceeding 90%.
9. The device cannot be used in places with temperature lower than +2°C or higher than +40°C.
10. Clean with damp cloth only.
The PX387 driver was designed to cooperate with the PX314 dimmer as an extension module,
but it can be used independently as a DMX signal controller.
The device sends 512 channels which are controlled on the ON/OFF basis or continuously with
the use of the slider. It is possible to check which channels are currently enabled and disabled.
PX387 allows you to create 16 zones to which you can assign any channel, determine their order
and define the size of the displayed buttons. It is possible to define the following two accounts in
the driver (administrator and user), which differ in the level of access to different functions.
The LAN connection is used to communicate with the environment. In this way, the PX387 can be
connected to the Accesspoint and thus controlled using the Android
™
smartphone.
3
2. SAFETY CONDITIONS
