PXM Splitter DMX-RDM, Руководство пользователя

Страница: 3 / 7

1. GENERAL INFORMATION
3
DMX-RDM signal splitter
This signal splitting device, or DMX-RDM splitter, allows for providing branches in extensive
DMX-RDM installations. As connecting multiple, series-connected receivers to form a single
chain can be difficult, provision has been made in the design of the splitter to create DMX-RDM
line branches. Moreover, the PX716 will amplify and regenerate RDM-DMX signal, removing
interference effects, as well as eliminating signal reflections on DMX-RDM lines.
The PX716 will split an input DMX-RDM signal into 4 independent branches. Galvanic isolation is
provided between individual outputs themselves as well as from the input, and the outputs are
adequately amplified, which ensures proper operation of the entire installation. The PX716
supports the RDM protocol. A maximum of four splitters can be connected in a cascading
arrangement.
The PX716 splitter has a metal housing. Additional mounting kits are available for installing a
single PX716 unit in a RACK system, two units side by side in a RACK system, or for suspending
a PX716 from e.g. a truss.
The PX716 is designed to run from 230 V AC mains.
2. SAFETY CONSIDERATIONS
The PX716 is a device powered directly from power grid 230 V, what may result in electric shock
in case of not following safety rules. During its installation and use the following rules must be
strictly observed:
1. Installation of the device should be carried out by a person with appropriate qualifications in
accordance with this document.
2. The electrical outlet to which the switch is connected have to be linked to a working protective
installation (3-wire installation.)
3. Protect the power cord from mechanical and thermal damage.
4. In case of damage the power cord, cable, replace it with the same technical data and
certificates.
5. For connecting devices to the Splitter use only 3-wire cables with cross-section of not less
than 1.5 mm.
6. Connection of DMX signal can only be made with shielded conductor.
7. All repairs and connections of outputs or DMX signal can only be made with cut off power
supply.
8. PX716 should be strictly protected against contact with water and other liquids.
9. All sudden shocks, particularly dropping, should be avoided.
10. The device cannot be turned on in places with humidity exceeding 80%.
o o
11. The device cannot be used in places with temperature lower than 2 C or higher than 40 C.
12. Clean it with damp duster only.