Pro Video Instruments
VeCOAX Network Compact HDMI RF Modulator Manual
9
Click APPLY to lock in changes. If the IP Address, etc., is changed, be sure to use the new IP
Address to access the unit’s web interface.
UPDATE TAB
: Provides the interface for unit Firmware updates.
ONLY USE AS DIRECTED BY PVI
SUPPORT STAFF.
ABOUT TAB
: Provides Firmware Version information.
INSTALLING MULTIPLE UNITS
To install multiple units on the same coax network, make sure to
CHANGE
the Frequencies,
Major/Minor, and Short Name of each unit
BEFORE
you connect them to the same coax network, so
there will be no Channel Conflicts. By default, each unit will be set the same. Please Test each unit
directly connected to a Test TV first with a short piece of coax before making it a permanent
installation such as a rack mount to make troubleshooting easier. Once you have all your
unit’s
setup
test again with a test tv first before combining the units with your coax network.
If you have other modulators or Digital signals you must find a harmony between the RF levels and
Frequencies that are available such as ATSC (Over the Air Antenna) signal. Check the operating
frequencies of the other signals (i.e. other modulators, OTA channels, etc.), and be sure to set these
units to other valid frequencies.
Depending on your setup we
recommend
for you to use an active splitter or combiner with more than
6 units, 40+ TVs or using multiple splitters (each splitter will lower the DB level 5-10dbs depending on
