PVA SV200, Руководство по эксплуатации

Страница: 12 / 13

Troubleshooting
Problem Possible Cause Corrective Action
Valve does not
cycle - Motor not connected properly
- Cured material in fluid section - Check motor connections
- Disassemble valve and clean
Material leaks
from valve tip - Fluid pressure too high
- Not enough reverse on auger - Decrease inlet fluid pressure
- Increase reverse time on auger
Valve leaks from
mid-section - O-ring is worn - Replace O-ring
Valve does not
dispense
anything - Fluid pressure is too low
- Cured material in fluid section - Increase fluid pressure
- Disassemble valve and clean
Air bubbles in
fluid - Valve not properly purged
- Air bubbles in syringe
- Reverse time set too high - Cycle valve open to purge air
- Remove air from syringe
- Reduce reverse time
Dispense rate too
fast - Motor speed set too high - Decrease motor speed
Dispense rate too
slow - Motor speed set too low - Increase motor speed