RD100 & RD200 PVA
Revision A (2016)
15 of 35
Logon
1.
Select
Logon
to change who is logged on and enter the necessary password.
2.
Use the key pad to enter the necessary pin and select
Enter.
Figure 10: Logon
Ready
Ready mode uses the settings from Setup mode to operate.
1.
Select
Ready
from Cyclestop.
2.
When the parts are correctly installed, use the HMI, foot pedal, or the finger
switches to activate a cycle. You must leave your finger in the finger switch for
the entire cycle.
3.
The heading in Ready mode will show either “Timed” or “Continuous”. This is
set in Setup mode. Timed mode will operate the rotary table and the valve for a
set amount of time. Continuous mode will operate the rotary table and the
valve as long as the button is held (this includes the pedal or the finger switch).
NOTE: The values shown cannot be changed in this screen.
Figure 11: Ready Mode
